Diary of a mad man part 2
#21
Registered
Thread Starter
Clean up and tested everything. The project seems to constantly grow in scope. Rebuild this and replace that.. trim tab pumps and all new relays. Rebuild Hydrolic rams... clean clean and more clean and more buffing...
. powder coat you name it
. powder coat you name it
The following users liked this post:
beckmwi (01-30-2024)
#23
Registered
Thread Starter
Forgive the typos and spelling.. putting this together from a phone sux...Started putting it back as I received parts and tried to work on it every chance I got.. after work and the weekends. Hot/ cold / rain u name it.. some of these pics might be out of sequence so bare with me.. I made a few mistakes along the way on my timing. sometimes a good idea should have been realized earlier on in the build. In the back of my mind I keep thinking about the cut canopies and how much I wish I could.find some more.. I was totally blown away what it would take to replace them.. ultimately I knew I needed to change the profile of the boat to work with what I had and the new direction with a wind screen/ shield look..
I decided to replace all my hoses and lines. Kept the Hydrolic steering lines from the helm.... But that was it.. all new stainless clamps etc.. i ended up rewiring everything. I'll show you some pics of the dash.redo later
I decided to replace all my hoses and lines. Kept the Hydrolic steering lines from the helm.... But that was it.. all new stainless clamps etc.. i ended up rewiring everything. I'll show you some pics of the dash.redo later
Last edited by tomcei; 01-27-2024 at 03:22 PM.
#24
Registered
Looking great, hope it comes out as nice as the Pantera. What are you doing for power?
The following users liked this post:
Twin O/B Sonic (02-01-2024)
#27
Registered
Thread Starter
As I was working to reassemble the bilge I was also stripping out the cock pit and helm. Like I said, hard to find a stopping point... sometimes we create our own pain..lol
Jack shaft assembly. New shaft and beargings
Geeze..lets get another
Mades sure all exposed was sealed up tight
Jack shaft assembly. New shaft and beargings
Geeze..lets get another
Mades sure all exposed was sealed up tight
#29
Registered
Thread Starter
Man, carpet and glue.. .. this part was so much fun.. had to scrape and use solvent....ultimately i wanted to paint some sections and upholster as well
Pulled the flooring...
Weighing my new dash options.. wasnt happy with the lay out and she needed some new guages.
#30
Registered
Thread Starter
Found some MTI seats a friend had and picked those up along the way. Still putting some ideas together for the dash. Also determined what I wanted to do on the profile. I didnt post the exact pic i thought but more or less im going with the bottom red line and cutting it there.
Last edited by tomcei; 01-29-2024 at 07:30 AM.
The following users liked this post:
hogie roll (01-29-2024)