Extreme Measures... Make Over Edition
#101
Registered
Thread Starter
Got a lot accomplished today. Got the engines set in. Had to spend quite a bit of time aligning the the gimbal bearing into the coupler. The outer stringers were replace so no holes were drilled. Had to get everything aligned, bolts tightened and C-clamped the mounts to the new stringers. then drilled out the holes.
Now need to plumb the new fuel system, wire the whole EFI system in and freshen up drives.
Now need to plumb the new fuel system, wire the whole EFI system in and freshen up drives.
#102
Platinum Member
Platinum Member
Looking very good now. Any updates on more progress?
The following users liked this post:
Rookie (07-22-2021)
#103
Registered
This thing is looking awesome and has been a great thread. I'm really looking forward to seeing it completed and in the water.
The following users liked this post:
TomZ (07-22-2021)
#104
Registered
Thread Starter
Slow progress. Realizing that my engines were originally out of my Panther I needed to build new engine wire harnesses, order all new Gaffrig senders, run/build all new oil lines and fuel system. wired analog/digital systems. (EFI) also new gimbal bearings. The rigging is so time consuming now that everything has to be wired nice and neat with proper planning. I bought so many -AN brackets, couplers, zip ties, hose/wire holder thingy mounts... I'm also moving batteries to level out the boat. It lists terribly to the starboard side. I plan to work on it all day tomorrow and maybe Saturday. Should be able to hopefully fire them next week.
During this time Valako (JimV) and I also moved out of our shop.
I have more pics of progress I'll add.
During this time Valako (JimV) and I also moved out of our shop.
I have more pics of progress I'll add.
Last edited by Rookie; 07-22-2021 at 08:48 PM.
#105
Registered
Thread Starter
Not much to update. Majority of August was mid 90°s and inside my pole barn was 100°+ after work. I did get my above list 90% complete.
Then I said f#ck it and broke out the Panther and have been boating the last 3 weeks!. lol
.
Then I said f#ck it and broke out the Panther and have been boating the last 3 weeks!. lol
.
Last edited by Rookie; 09-15-2021 at 10:07 PM.
The following 4 users liked this post by Rookie:
#106
Platinum Member
Platinum Member
It's been awhile so any updates on the progress lately?
#108
Registered
Thread Starter
I have the boat all wired up, EFI installed, relays, fuses, fuel. Need to put on headers, throttle linkage, rebuilding Bravos, install interior and I should be done. Also have other projects going on. Not too far away from completing.
.
.
#110
Platinum Member
Platinum Member
Ok, you are well over due for a update on this project....