Updating 2000 31 American " The Freak "
06-16-2021, 07:58 AM
#34
Platinum Member
Platinum Member
looks good, I think I saw you looking for parts ? looks like you found some
06-16-2021, 08:02 AM
#35
Platinum Member
Platinum MemberThread Starter
Freak project
Got the boat from fiberglass,, Got everything pretty inside.. they sanding and repainting and gel all the old holes filled and sealed.. and Put the the number 5 drives on. Next is mocking up the engine and seeing where everything is going to fit.. One issue I am having is I need some rear motor mounts,,So I am on the look out for some. I need 2...
06-28-2021, 11:20 AM
#38
Platinum Member
Platinum MemberThread Starter
I found the rear motor mounts and now looking for Tie bar that is a 5 drive set up...57 1/2 inches.. Currently I am using bravo style for mock up... Should have my heads back soon.. Just order cams.. there are about 6 weeks out.. Ifters are Like 2 weeks.. Right now mock up engine to put in so that we can see where everything will go.
04-03-2023, 08:50 AM
#39
Platinum Member
Platinum MemberThread Starter
Update.. Sorry for delay.. Custom parts have been hard to come by..It took 8 months for
push rods, 5 months for Intakes,4 months for custom valve covers with sprayers in them.. But now we are finally here now.. Motors are together.. Been painted.. Still doing paining on bell housings and transmission. But coming together.. Next is bringing the boat to Steve so they can do a mark up and drill all holes for the motor mounts and etc...in a couple weeks..
push rods, 5 months for Intakes,4 months for custom valve covers with sprayers in them.. But now we are finally here now.. Motors are together.. Been painted.. Still doing paining on bell housings and transmission. But coming together.. Next is bringing the boat to Steve so they can do a mark up and drill all holes for the motor mounts and etc...in a couple weeks..
