upholstry access ??
08-13-2007, 10:53 AM
#1
Registered
Thread Starter
Join Date: Aug 2004
Location: Fairhaven, MD.
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
upholstry access ??
This is probably a stupid question but here goes. I have a '97 Top Gun and I need to replace the padded rail that runs across the front of the dash and down the sides next to the 2 front seats. I would think that there is a strip of plywood that is upholstered and then attached to the fiberglass.
How do you get access to attach/unattach this piece? Do you have to take the cockpit side panels off to get to the underside or is the plywood srewed down and then upholstered in place??? I'm hoping there's a simple answer.
Thanks-
How do you get access to attach/unattach this piece? Do you have to take the cockpit side panels off to get to the underside or is the plywood srewed down and then upholstered in place??? I'm hoping there's a simple answer.
Thanks-
08-13-2007, 11:43 AM
#2
Registered
Join Date: Jul 2006
Location: Ft. Lauderdale Florida & Tarpon Springs Florida
Posts: 886
Likes: 0
Received 0 Likes
on
0 Posts
Dont have to take anything apart... take a screwdriver or small pry bar and tape theend so you do not scratch the boat and just pry. They are all attached by those "christmas tree" things that just push in. There are no screws or bolts !!
08-13-2007, 04:08 PM
#5
Registered
Thread Starter
Join Date: Aug 2004
Location: Fairhaven, MD.
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
I could have only hoped for that answer. I think this is the first time with this project that anything turned out easier than I thought it would be !!
Thanks for the info Tanner-
Thanks for the info Tanner-
