Nauti by Nature Cigarette 38 Top Gun Refresh!!
05-31-2013, 09:12 AM
#173
Registered
Thread Starter
Join Date: Jun 2011
Posts: 863
Likes: 0
Received 0 Likes
on
0 Posts
We made everything we need to dyno the engines just like they run in the boat!! We finished up all the brackets, hoses, tail pipes with 02 sensors etc etc late last night!
We were able to fire it up and seat the rings!! Should have some numbers today.
First Fire Off Video ( Click the link to view)
On the Dyno - We have dyno valve covers on so the paint job didnt get messed up!!
We were able to fire it up and seat the rings!! Should have some numbers today.
First Fire Off Video ( Click the link to view)
On the Dyno - We have dyno valve covers on so the paint job didnt get messed up!!
05-31-2013, 03:19 PM
#174
Charter Member#330
Charter Member
Looks great. If you can Dyno the motor with and without the flame arrestor. Would like to see the difference with the low flame arrestor. I have had this discussion with a few people before
Keep up the Great work
Mark
Keep up the Great work
Mark
__________________
If you like it rough do it OFFSHORE!!!
If you like it rough do it OFFSHORE!!!
05-31-2013, 08:14 PM
#175
Registered User
Platinum MemberJoin Date: Aug 2011
Location: New Port Richey, FL
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
1 engine down 1 to go. Lets just say it made pretty good steam. Marks all smiles!!! I will test the flame arresters back to back for you tomorrow and post results. Thanks Joe Irwin
06-01-2013, 02:17 AM
#177
Registered
Thread Starter
Join Date: Jun 2011
Posts: 863
Likes: 0
Received 0 Likes
on
0 Posts
Well we have some 925's in the boat now!!
First Engine made 926hp @ 6100 rpm!! That was a super safe tune up with 93 octane pump gas and 6lbs boost! Second engine is fired off with the 925 tune up loaded into it so we can check it tomorrow.... It was getting to late to run the engine tonight.
Click the picture to view the video
Click the picture to view the video
Joe Irwin from Fast Forward Race Engines in the Dyno Room!!
First Engine made 926hp @ 6100 rpm!! That was a super safe tune up with 93 octane pump gas and 6lbs boost! Second engine is fired off with the 925 tune up loaded into it so we can check it tomorrow.... It was getting to late to run the engine tonight.
Click the picture to view the video
Click the picture to view the video
Joe Irwin from Fast Forward Race Engines in the Dyno Room!!
06-01-2013, 02:35 AM
#179
Registered
Thread Starter
Join Date: Jun 2011
Posts: 863
Likes: 0
Received 0 Likes
on
0 Posts
Joe is going to run a back to back test tomorrow... From what I have seen so far they make the same power on or off..
