Cafe Racer throttle question
#21
Registered
That place is impressive, I just snooped around their site:
http://www.ottoexcellence.com/about/visual-tour.aspx
http://www.ottoexcellence.com/about/visual-tour.aspx
#22
Registered
#23
Registered
#24
Registered
Thread Starter
Here is what I ended up doing. I replaced the port and starboard start switch as well as the parallel start switch with the push buttons I listed above. They look nice, seem to be decent quality also. I had to drill the plate to 5/8 so they would fit. The parallel switch is actually a two position switch so what I ended up doing with that is moving that switch down to the side where my now defunct fume alarm had a switch mounted and installed the push button as a blank. It all works as it should and things are much more comfortable with the shifter.
[ATTACH=CONFIG]555871[/ATTACH]
[ATTACH=CONFIG]555872[/ATTACH]
[ATTACH=CONFIG]555871[/ATTACH]
[ATTACH=CONFIG]555872[/ATTACH]