Blackmagic94

86 cafe racer


I have no power to circuit 50 on the fuse panel. I also have no power to switch for nav/anchor. Is 50 the circuit for that

CIG3

Should be power from Port Battery. Curcuit #50 is Fuel pump. Nav lights should be #23

BDiggity

It's been so long, i cant remember if the engine switches in cabin need to be on to then power the fuel pump circuits.
23 is for the nav's as stated above.

Blackmagic94

I've tried it both ways but that far left circuit. Not sure if 51 now has no power on test light on either side. I have no stern light and I have no nav and anchor lights nor does the switch light up.

kvogt

If I remember correctly the electric fuel pumps go through a oil pressure switch to get power.

Blackmagic94

Fuel pumps have power

it's not circuit 50. But there are two dead. Far left and one middle one with a top black wire. I'll go look in a bit and get numbers.

Blackmagic94

Also what type of anchor light fixture does these use. Not a normal perko twist pole

CIG3

Perko Figure 1125 (3 pin)
Perko Figure 1209 (2 Pin)