Cigarette Topgun
#391
Registered
Thread Starter
Main stringer on port side in cabin
4 hours later a few carbon blades on the isolatior tool 12 pack of Pepsi and a lot of thinking “what the hell am I doing” I got all the port side cabin stringers out
#392
Registered
Thread Starter
Anyone in the Cleveland area have a few screw jacks I could use for a few weeks. I’d like to put a few more under it to make sure it’s supported real good before I glass new stuff in
#394
VIP Member
VIP Member
what type of trailer do you have. mycos are built for the bottom and support it fully, if you have one let it sit on there. you can level it with jacks and have full support. When mark at rage did my tanks and he cut the floor out the boat it snapped back into shape, whomever did the second set of tanks put it together under a bind.
The following users liked this post:
Tartilla (04-15-2024)
#396
Registered
Thread Starter
OK so this is been my biggest concern now that every stringer is cut out of this boat right now I have 2 stands at the far back 2 stands midship in the keel sitting on a block in one spot towards the front my trailer is a bottom support bunk trailer that does seem to have a lot of areas where it supports the boat is it best to put it back on trailer if I do that I cannot use stand anywhere or do I just use for stands for side and try to support the Keal. My concern is what if the trailer is a bit unleavened or not built to square the boat ran very well before and the bottom is blue printed so I would like to not glassy hook back into it lol I was thinking just a bunch of stands get a supported and go from there
#398
Registered
What I did was probably overkill.
I used 12 stands and supported the keel in three places.
I only worked one section of the boat at a time, so I didn't remove all of the inner hull support.
I used 12 stands and supported the keel in three places.
I only worked one section of the boat at a time, so I didn't remove all of the inner hull support.
#399
VIP Member
VIP Member
OK so this is been my biggest concern now that every stringer is cut out of this boat right now I have 2 stands at the far back 2 stands midship in the keel sitting on a block in one spot towards the front my trailer is a bottom support bunk trailer that does seem to have a lot of areas where it supports the boat is it best to put it back on trailer if I do that I cannot use stand anywhere or do I just use for stands for side and try to support the Keal. My concern is what if the trailer is a bit unleavened or not built to square the boat ran very well before and the bottom is blue printed so I would like to not glassy hook back into it lol I was thinking just a bunch of stands get a supported and go from there
Last edited by offshoredrillin; 01-02-2020 at 10:28 AM.