Tie bar for 888 drive
#1
Registered
Thread Starter
Join Date: Apr 2006
Location: Brighton, MI
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Tie bar for 888 drive
Anyone ever put a tie bar set up on one of these? I would like to, and also drive showers of some kind. Anyone have any experience with this?
#4
Registered
nope... thats a phragle original. and the only problem was my bone headed use of cheap steel heims... replaced with staInless and good to go. Theres really not much to building one if you have a press and a lathe........
#6
Registered
Thread Starter
Join Date: Apr 2006
Location: Brighton, MI
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Although I do have access to those....I was really hoping not to have to make one. I feel like I have seen a couple over the years just never needed one until now....lol go figure.
#9
Charter Member
Charter Member
I have a stainless 1-1/4" tie bar with the stainless heim ends if you still need one, the heim ends only have about 20 hours of running time before we went to all new steering and bars.
__________________
Thanks, Barry
Driver - High's Fuel Your Journey Cigarette Racing Team #598
Thanks, Barry
Driver - High's Fuel Your Journey Cigarette Racing Team #598