#99 gentry 46' scarab restoratoin
#233
Registered
#234
Platinum Member
Platinum Member
Thread Starter
Engine room is cleaned and finally ready for the 3rd engine. Drive decals turned out amazing
[ATTACH=CONFIG]558208[/ATTACH][ATTACH=CONFIG]558209[/ATTACH]
[ATTACH=CONFIG]558208[/ATTACH][ATTACH=CONFIG]558209[/ATTACH]
#235
Platinum Member
Platinum Member
Thread Starter
The Gentry 3 are installed just about ready for exhaust.[ATTACH=CONFIG]558255[/ATTACH]
The 3 Kiekhaefer Drives install with trim tabs [ATTACH=CONFIG]558256[/ATTACH][ATTACH=CONFIG]558257[/ATTACH]
And the new seat is done.[ATTACH=CONFIG]558258[/ATTACH]
The 3 Kiekhaefer Drives install with trim tabs [ATTACH=CONFIG]558256[/ATTACH][ATTACH=CONFIG]558257[/ATTACH]
And the new seat is done.[ATTACH=CONFIG]558258[/ATTACH]
#237
Platinum Member
Platinum Member
Incredible build and attention to detail!
Question/observation - With all those fuel fills and vents on the deck, it seems like the crew would be constantly smelling and misted with gas with full tanks.
Question/observation - With all those fuel fills and vents on the deck, it seems like the crew would be constantly smelling and misted with gas with full tanks.
#238
Registered
Serious note, on my crappy computer it looks like a panel that hasn't been put down yet, but is resting on frt of boat during pic. I dunno.
#240
Platinum Member
Platinum Member
Thread Starter
The trailer goes in for its makeover after we lift the boat on to the dipster trailer that we had built for the boat that's under Smokin Joe right now. As for the fuel fills they are Dry Breaks they don't leak they are spring loaded and a pain to use stiff springs.