Scorpion powerboats
#55
Registered
Join Date: Dec 2003
Location: St.Thomas USVI
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
Pics of the progress. Floors,
[ATTACH=CONFIG]535943[/ATTACH][ATTACH=CONFIG]535946[/ATTACH][ATTACH=CONFIG]535945[/ATTACH][ATTACH=CONFIG]535944[/ATTACH]
Setting up front seat to position tee nuts in floors. Also sketching out plans for rear beach seats. Keeping the original seat bases. Looks like it's gonna be a stand up bolster.
Setting up front seat to position tee nuts in floors. Also sketching out plans for rear beach seats. Keeping the original seat bases. Looks like it's gonna be a stand up bolster.
#59
Registered
Join Date: Dec 2003
Location: St.Thomas USVI
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
[ATTACH=CONFIG]535954[/ATTACH][ATTACH=CONFIG]535953[/ATTACH][ATTACH=CONFIG]535952[/ATTACH]
Laminate cabinets, interior LED cup holders, LED interior lights. Had a few LED lights left over from the house so we installed them in the boat.
Laminate cabinets, interior LED cup holders, LED interior lights. Had a few LED lights left over from the house so we installed them in the boat.
#60
Registered
Join Date: Dec 2003
Location: St.Thomas USVI
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
Progress pics 37 scorpion
[ATTACH=CONFIG]535955[/ATTACH][ATTACH=CONFIG]535956[/ATTACH][ATTACH=CONFIG]535957[/ATTACH][ATTACH=CONFIG]535958[/ATTACH]
Work on the engine hatches. Went with a low profile design . Looking for stainless steel mesh for the air Inlets or a honeycomb design. Any ideas ?
Work on the engine hatches. Went with a low profile design . Looking for stainless steel mesh for the air Inlets or a honeycomb design. Any ideas ?