572 DFI Procharger Build
#321
Registered
Thread Starter
Join Date: Jul 2003
Location: Watkins Glen
Posts: 633
Likes: 0
Received 0 Likes
on
0 Posts
#322
Registered
Smaller cam, smaller heads, less boost more power???
I cant imagine the M4 is using that much less power than my M5. I have the dyno set as it would be in the boat. everything is on it, pwr steeering, water pump, alt.
I really wonder if my headers are the restriction I have the E-tops. I might see if I can get a larger set for the dyno just to compare.
I cant imagine the M4 is using that much less power than my M5. I have the dyno set as it would be in the boat. everything is on it, pwr steeering, water pump, alt.
I really wonder if my headers are the restriction I have the E-tops. I might see if I can get a larger set for the dyno just to compare.
Alt, water, no pwr steering on this motor
#323
Registered
Randy
#325
Registered
Sorry ...Fridays pull 14.6 AFR .....would of spelled melt down .... though the knock meters didn't jump at all??
#327
Registered
#328
Registered
Thread Starter
Join Date: Jul 2003
Location: Watkins Glen
Posts: 633
Likes: 0
Received 0 Likes
on
0 Posts
Update
Feels like I have been here before… the new pistons are more like a NA motor with the D shape dish to take advantage of good quench when not in boost, the old pistons were just a dish with a valve relief. Plus the skirts and tops are coated…
The head gaskets are custom made, Cometic does not stock a MLS for the Merlin block..
The new cam specs are slightly less duration, more lift 112 LC and 5 deg built in advance. The regrind is the new card.
I hope it’s dressed tomorrow and on the dyno Thursday, it will be interesting. I hope to have some more in the bottom end and mid, but not lose anything up top. We will see…
The head gaskets are custom made, Cometic does not stock a MLS for the Merlin block..
The new cam specs are slightly less duration, more lift 112 LC and 5 deg built in advance. The regrind is the new card.
I hope it’s dressed tomorrow and on the dyno Thursday, it will be interesting. I hope to have some more in the bottom end and mid, but not lose anything up top. We will see…
#329
Registered
Thread Starter
Join Date: Jul 2003
Location: Watkins Glen
Posts: 633
Likes: 0
Received 0 Likes
on
0 Posts
Getting there, should be on the dyno by Friday, and in the boat sometime over the weekend. Water testing Monday.
Some pics of the damaged pistons. At least 4 were this bad. Interesting it was near the intake valve relief. It is a thin area. You can see it is out of round there, got really hot expanded scrubbed against the cyl wall and warped due to heat. I have a NTK O2 to test with accel said the standard O2 sensor can be of up to 1 AF under boost. I will see. I have not found any big tube headers to try yet.
Some pics of the damaged pistons. At least 4 were this bad. Interesting it was near the intake valve relief. It is a thin area. You can see it is out of round there, got really hot expanded scrubbed against the cyl wall and warped due to heat. I have a NTK O2 to test with accel said the standard O2 sensor can be of up to 1 AF under boost. I will see. I have not found any big tube headers to try yet.