496 Alarm sending units location
#1
Registered
Thread Starter
Join Date: Dec 2011
Location: Colonial Beach, VA
Posts: 272
Likes: 0
Received 0 Likes
on
0 Posts
496 Alarm sending units location
Time to start working on the boat again. I noticed when I replaced all my gauges that the wire for the Overtemp/Oil Pressure/Drive Lube alarm was cut by a PO When I reconnected it, it alarmed right away. All conditions on the gauges and in Smartcraft are good. This tells me I have a bad idiot light sensor. Where are the idiot light sensors physically located on the 496? It is a Dec 2002 model. These are the only three sensors in serial for this alarm, right?
Thanks!
Thanks!