nailit

Move down here, can get beer anywhere, anytime! Great thread! Thanks

KNOT-RIGHT

Then we would really get Sh@t done..
Alcohol the cause of problems yet the cure.
install the hollow bolt protector

KNOT-RIGHT

install puller base and install puller
what should happen here is it should push the 2nd pt rotor out of the bearing housing.

KNOT-RIGHT

it was so cold i had to keep that blanket on it to keep it warm
it looks like this now

KNOT-RIGHT

here is the bearing housing. take a look at it it is clearly evident tha it was leaking
by the coking deposits.

KNOT-RIGHT

here is the flip side
it obviously presses out from this side.

KNOT-RIGHT

here it is new seal installed

KNOT-RIGHT

i know my saftey wiring looks like i got turrets

KNOT-RIGHT

Pt reassembly
drop exhaust diffuser back on

KNOT-RIGHT

The center spanner nut was torqued to 250ft lbs
dont forget to peen over the stop washer.
i used three12 point bolts to pull in the diffuser first before i tightened the counter sunk Phillips screws