Just Turbines
02-19-2014, 05:22 PM
#411
Registered
Thread Starter
If you are having a start issue its most likely one of the above.
02-20-2014, 11:05 AM
#412
Registered
Thread Starter
this was actually putting a RF line in my iphone when filming. Radio frequency not Reggie fountain
http://youtu.be/bAq4JINUIkY
http://youtu.be/bAq4JINUIkY
03-01-2014, 07:13 AM
#413
Registered
Thread Starter
Parts are now in from PPS.
The reassembly processes is as follows.
This is now the 703 version.
here is the illustration
.
The reassembly processes is as follows.
This is now the 703 version.
here is the illustration
.
03-01-2014, 07:14 AM
#414
Registered
Thread Starter
Mount modified diffuser
03-01-2014, 07:15 AM
#415
Registered
Thread Starter
Nice big sea scallops
03-01-2014, 07:23 AM
#416
Registered
Thread Starter
bolt down diffuser first then safety wire
03-01-2014, 07:25 AM
#417
Registered
Thread Starter
install seal item 4 above.
I put it outside for too hours its like 7 out.
and heated the diffuser ring with my torch and she fell right in.
observe seal orientation
I put it outside for too hours its like 7 out.
and heated the diffuser ring with my torch and she fell right in.
observe seal orientation
03-01-2014, 07:26 AM
#418
Registered
Thread Starter
i got this bad boy if that method of installation came up short
03-01-2014, 07:28 AM
#419
Registered
Thread Starter
install items 5,6,7
seal retainer
shim and spiral c clip
seal retainer
shim and spiral c clip
03-01-2014, 01:45 PM
#420
Registered
Thread Starter
install 8,9,10
bearing and crush seals
and 703 bearing housing that mates with the new machined diffuser
bearing and crush seals
and 703 bearing housing that mates with the new machined diffuser
