Bravo XR Shift Cable Adjustment Tools
06-10-2018, 09:56 AM
#1
VIP Member
VIP MemberThread Starter
Bravo XR Shift Cable Adjustment Tools
Starboard shift cable, from drive to on engine acutuator, had a kink near the business end in it since I have owned the boat. It was straightened out but after a few r and r of the drives and a missed correct cable install by me the cable has a kink and needs replaced. Can someone confirm the tool part #s I need. There are 2 one for the ball end and on for the actuator side. So far I have found 91-12427T Merc or 18-9807 Sierra equivalent but cannot find the 2nd tool #. Any help would be appreciated.
06-10-2018, 11:18 AM
#2
VIP Member
VIP Member
This is the one used at the bell housing, it’s a 91-17263
06-10-2018, 11:21 AM
#3
VIP Member
VIP Member
Looks like this
06-10-2018, 11:30 AM
#4
VIP Member
VIP Member
Other one is a 91-17262 looks like this
06-10-2018, 12:00 PM
#5
Banned
just buy these part number is on label 18- 9810 Sierra they are fine. I have them about 10 - here is a pics of what I have., ebay amazon like 35 to 50 bucks for the kit.
06-10-2018, 12:02 PM
#6
Banned
just buy these part number is on label 18- 9810 Sierra they are fine. I have them about 10 - here is a pics of what I have., ebay amazon like 35 to 50 bucks for the kit.
06-10-2018, 12:04 PM
#7
Banned
If any interest shipped 50 bucks to the door for whomever.
And if one is changing the shift cable buy the Merc one in kit form. . The bellows is better as well than the aftermarkets
And if one is changing the shift cable buy the Merc one in kit form. . The bellows is better as well than the aftermarkets
06-10-2018, 12:57 PM
#10
Registered
I have all the tools and last time I replaced one, I didn't use any of them. The new cable came pre-pinned (adjusted to correct length). All I did was make sure I had 3 inch pin to pin on the shift plate, installed and it work perfect.
