Hard Shifting
#1
Registered
Thread Starter
Hard Shifting
my bravo is very hard to get into reverse.i disconnected the shifter at the motor,shifter moves easy.i pulled the drive and lower shifter cable moves easy.someone told me that with the lower cable connected to drive it can bind on the inside of cable casing.is this true?can my problem be in the drive?i service my drive every 20 hrs with synthetic fluid and no metal on drain plug.
#2
Charter Member #601
Charter Member
awesome,
Check to see if there is any crimps or kinks in the cable. If there is, it should move fairly hard, but you say the lower cable moves freely.
First rule, you must rotate the input shaft while shifting!!!
Second rule, see first rule again.
With the drive off, it is possible to shift the drive while rotating the input shaft. I use a finish nail with a brass bead on the end. Fits in the shifter pretty good. Then you can shift it from fwd to neut, to rev.. it should move the same in each gear and direction. There is a detent ball that you are fighting, with a strong spring.. So it will snap into each position.. If if doesnt, then the shift linkage inside may have problems.
If you get that far.. and still have a problem, and feel you want to go inside the drive it is probably easier to explain on the phone..
D*ck
616-335-8446
Check to see if there is any crimps or kinks in the cable. If there is, it should move fairly hard, but you say the lower cable moves freely.
First rule, you must rotate the input shaft while shifting!!!
Second rule, see first rule again.
With the drive off, it is possible to shift the drive while rotating the input shaft. I use a finish nail with a brass bead on the end. Fits in the shifter pretty good. Then you can shift it from fwd to neut, to rev.. it should move the same in each gear and direction. There is a detent ball that you are fighting, with a strong spring.. So it will snap into each position.. If if doesnt, then the shift linkage inside may have problems.
If you get that far.. and still have a problem, and feel you want to go inside the drive it is probably easier to explain on the phone..
D*ck
616-335-8446
#3
Registered
Hey Awesome I had the same problem with shifting into reverse, but had some metal in the oil....getting the outdrive rebuilt(mostly in the upper) and also getting a new gimbal hopefully this will help mine. I think it's getting a new cable, suspecting that was the problem.....will let you know when I see it.
#4
Registered
i am having the same problem. shift easy into forward and very hard to get in to reverse. It started after i pulled the drive then put i back on and changed fluid. what do i need to do ?
#5
Registered
Thread Starter
mine shifts into forward no problem,its only in reverse thats hard.i think i should put a cable in just cause.mr g i did take the back cover off and lube the detent ball and spring,but no luck.i think i will do the cable this weekend and see what happens.may call you next week.camp did they find anything wrong in the upper drive?
#6
Registered
#7
Registered
hey Awesome, got the boat home yesterday, Upper gears were chewed up and the shift cable was kinda stiff. Have'nt lake tested it yet put think it was a combo of both that made it hard shifting.Any luck with yours?
#9
Registered
It comes off the throttle linkage then inbetween steering rack and exhaust then through the housing, I try to post a pic tomorrow if the weather still good, no 90 turn just slight bend