possible drive fluid leak
#1
Registered
Thread Starter
Join Date: Feb 2003
Location: SML VA
Posts: 2,952
Likes: 0
Received 0 Likes
on
0 Posts
possible drive fluid leak
have a xr drive with ITS took it out with res bottle full, then alarm went off so filled up as i was putting on trailer, sat for 5 days and when i checked the bottle again it was empty, but no fluid in the bilge or under drive on the pavement, so filled it up again and took the boat out and had to refill the res bottle 2 more times, so my question is can it just be an air bubble in the drive or could it possibly be leaking thru check valve, but why no signs of fluid underneath,
i was thinking of pulling drive to do full leakdown but should i try and just change the fluid and see if that would be the prob,
anybody ever had to fill the bottle more than 3 times?
i was thinking of pulling drive to do full leakdown but should i try and just change the fluid and see if that would be the prob,
anybody ever had to fill the bottle more than 3 times?
#6
Charter Member #601
Charter Member
Being an XR drive, if the input shaft seal retainer has not been replaced with the upgrade unit, then it probably has pushed the seal into the yoke an ate it.. Pull the drive, look in the bellows. If you seen any lube there.. the seal is probably at fault. A new reatainer seal kit is needed.
Hope this helps.
Dick
Hope this helps.
Dick
#8
FIERCE ALLEGIANCE
Platinum Member
Join Date: Jun 2003
Location: West palm Beach, FL & SML VA
Posts: 1,207
Likes: 0
Received 0 Likes
on
0 Posts
Will, take the top plug out and see if anything comes out. If it comes out you should have enough to not cause harm, unless you added a gallon or 2. Also, what is the color of the fluid. If black, it might have gotton hot. Probably should have the fluid changed at least. Lastly, if you can pull the drive, look inside the bellows. This is where mine was leaking but it was because of a chitty casing. Another $1000 bucks spent fixing a drive with 20 house on it. Great for me! ;(
#10
Registered
Thread Starter
Join Date: Feb 2003
Location: SML VA
Posts: 2,952
Likes: 0
Received 0 Likes
on
0 Posts
good thing i pulled em!
bearings were dry, lot of condensation from where it sat for 2 years without grease! going to replace both seals, gimbal bearings and u-joints, glad it leaked now so it showed a possible problem, instead of 50 miles down the river!
bearings were dry, lot of condensation from where it sat for 2 years without grease! going to replace both seals, gimbal bearings and u-joints, glad it leaked now so it showed a possible problem, instead of 50 miles down the river!