Heat Lamp
#1
Registered
Thread Starter
Heat Lamp
Just wondering if anyone uses the Merc. heat lamp when removing bearing races when rebuilding an out drive?Does it really make it much easier and how about using a heat gun.I was thinking the steel race would expand faster then the aluminum and make it harder to remove?Any thoughts
Thanks Nordic95
Thanks Nordic95
#2
I hate the winter!!
Platinum Member
Join Date: Jul 2001
Location: long island, new york
Posts: 2,707
Likes: 0
Received 0 Likes
on
0 Posts
I have used M.A.P. gas to warm up drive cases with success. Most times, you dont need to. However, you need all the help you can get, when getting a broken lower vertical shaft bearing out of a case.