IMCO SCX Problem
#71
Registered
Platinum Member
Join Date: Sep 2003
Location: Fort Erie Ontario Canada
Posts: 521
Likes: 0
Received 1 Like
on
1 Post
I have had drive for 15 hrs, no problems, sent back for hard shifting and delayed engagement sometimes, Dave at Imco was a pleasure to deal with and is even painting drives again. I guess mine where few serial #'s of the new cam change. So far very happy with drive.
I am running a sc lower, have some metal on magnet, may upgrade to imco lowers.I don't know about porous but if it was, I am sure it was in the beginning and has been adressed
I am running a sc lower, have some metal on magnet, may upgrade to imco lowers.I don't know about porous but if it was, I am sure it was in the beginning and has been adressed
#72
Charter Member #601
Charter Member
The porous problem was in the casting on the outside by the trim pin area. Not porous to the inside causing any leaks. And Imco took care of the problem to the customer's satisfaction, I was told.
Hope that helps.
Dick
Hope that helps.
Dick
#73
Registered
VIP Member
Join Date: Dec 2011
Location: Gunnison Co
Posts: 262
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Dick, Still thrashing around between the SCX and Arneson.
#74
Geronimo36
Gold Member
Got my drive back today looks great. Got a new Manuel with it. The only thing different I could find is this cable warning sheet was in with the Warning... Please read carefully . Now my question is…is there a different cable for left and right hand rotation??? If not... I am taking it that the RH rotation is ok with the shoulder on the cable. I will check my cable tomorrow to see if mine has a shoulder on not on it. My drive is RH (confused agene).
The new owner of BMax has figured out how to make it a permanent fix.