TRS gimbal housing won’t come off
07-18-2024, 09:06 AM
#11
Registered
There was a cork gasket on the outside of the gimbal housings. I believe Marc from BAM can still get them. As for the inside if the transom is flat you should not need any sealer. Glad it worked out.
07-20-2024, 09:19 AM
#12
Gold Member
Gold Member
Seaford what did you get ? How did you find it ?
We need or i need an official;
know a guy that knows a guy who has a cousin who's neighbor down the street drives by an old (xxxx) sitting in a field and the owner wants it gone thread
cuz they're out there and i need another project, a keeper, small single. 20 foot max, leaning ski boat but 16-18 donzi, a u17, a resorter, small light, small block direct drive is tops but a sawzall and tape measure fits a donor vdrive into a 16-18
We need or i need an official;
know a guy that knows a guy who has a cousin who's neighbor down the street drives by an old (xxxx) sitting in a field and the owner wants it gone thread
cuz they're out there and i need another project, a keeper, small single. 20 foot max, leaning ski boat but 16-18 donzi, a u17, a resorter, small light, small block direct drive is tops but a sawzall and tape measure fits a donor vdrive into a 16-18
Facebook Marketplace! - the world’s most dangerous app.
I had a bad run a couple months ago - bought this, an old wellcraft, an equipment trailer and a backhoe in a 3 or 4 week span. Even my wife, who never bats an eye at my antics, started to question my sanity. I put a self-imposed marketplace ban on myself, but I’m easing out of it…..
