Today in the shop part 2
#1
Registered
Thread Starter
Today in the shop part 2
No, you haven't crossed into an alternate universe...
Too Old is boating (in a Formula no less) and I'm working on mine.
moved 2 guages, and put in plotter. The wheel is from Trick Marine.
Too Old is boating (in a Formula no less) and I'm working on mine.
moved 2 guages, and put in plotter. The wheel is from Trick Marine.
#2
Registered
Thread Starter
Re: Today in the shop part 2
the plotter was a tight fit, though I had downloaded the template and sized this all up ahead of the purchase. Tight fit between guages and the "FasTech" on the panel...and the hinge arm on the outside. All is well.
#3
Registered
Thread Starter
Re: Today in the shop part 2
transom stereo remote added (they are standard now..as of '04 I believe). On the other side, are the transom trim switches.
These trim switches should be stock. Great to have at the beach and on the trailer. I've put 'em on my last 3 boats. plug and play, though I had to make a harness extension for the port side to reach around the perimeter to the bulkhead mounted pump for port.
I also made the 4 wire harness for the stereo remote. Tap spliced it into the wires at the dash remote.
I have another one...and am considering putting it in the backseat area.
These trim switches should be stock. Great to have at the beach and on the trailer. I've put 'em on my last 3 boats. plug and play, though I had to make a harness extension for the port side to reach around the perimeter to the bulkhead mounted pump for port.
I also made the 4 wire harness for the stereo remote. Tap spliced it into the wires at the dash remote.
I have another one...and am considering putting it in the backseat area.
Last edited by Rippem; 05-29-2005 at 08:15 PM.
#4
Registered
Thread Starter
Re: Today in the shop part 2
I botched the trim switches sort of. Not as straight and clean as the usual...I'll have to live with it.
You do have to heat the decal up on one, cut out a little half circle with a razoo for the bezel screw. and turn it over (put the switch in upside down)...so the rockers are both on the "inside" for easy "peace sign" two finger manipulation.
You do have to heat the decal up on one, cut out a little half circle with a razoo for the bezel screw. and turn it over (put the switch in upside down)...so the rockers are both on the "inside" for easy "peace sign" two finger manipulation.
Last edited by Rippem; 05-29-2005 at 08:18 PM.
#5
Registered
Thread Starter
Re: Today in the shop part 2
the mattress is almost done (see other thread). I've decided to cover it in 2 layers of a "heather" light grey polycotton jersy sheet type material. Soft, breathable, and ....cheap!
six Infinity Reference speakers scattered in the cockpit are the next reason to saw holes in the boat.
I have a couple Rockford 10" subs on hand also...
six Infinity Reference speakers scattered in the cockpit are the next reason to saw holes in the boat.
I have a couple Rockford 10" subs on hand also...
#8
Registered
Thread Starter
Re: Today in the shop part 2
Originally Posted by ThirdBird
Your transom is starting to look like a dash board. Oughta just mount some throttles and a wheel back there and you'll never have to get onboard!!!!!