Engine room treadplate
#1
Registered
Thread Starter
Join Date: Sep 2003
Location: Toledo, Ohio/Las Vegas, NV
Posts: 3,029
Likes: 0
Received 1 Like
on
1 Post
Engine room treadplate
Replacing the rubber mat on the step in my engine room with powdercoated aluminum treadplate. Rubber was looking pretty bad. Custom fabricated deal.
Before/after:
Before/after:
#5
Registered
Thread Starter
Join Date: Sep 2003
Location: Toledo, Ohio/Las Vegas, NV
Posts: 3,029
Likes: 0
Received 1 Like
on
1 Post
Re: Engine room treadplate
Probably about the same weight as the rubber. I used the 1/16" treadbrite which is the same thickness as the rubber mat. It is actually a little flimsy, but it is secured to 3/4" plywood so I don't think it will matter. I would have preferred to use the 1/8" treadplate ... it is pretty stout but it is also a fair bit heavier.
#6
Registered
Re: Engine room treadplate
Garrett, if you decide to do that, you better show me some pics
Looks like it is going to be sweet Chris. I'm ready to see what it looks like installed
Corey
Looks like it is going to be sweet Chris. I'm ready to see what it looks like installed
Corey
#7
Registered
Join Date: Nov 2005
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
Re: Engine room treadplate
Hi Corey,
I'll probably wait a little while on the mod's. I talked to Mike today. Sounds like the boat is running really great. Weather permitting, I'll be driving out to pick it up on the 27th and get the boat on the morning of the 28th. I think.
I bet that aluminum tread plate would look good anodized black. But, the powder coat is probably better at resisting corrosion, I'm guessing.
Garrett
I'll probably wait a little while on the mod's. I talked to Mike today. Sounds like the boat is running really great. Weather permitting, I'll be driving out to pick it up on the 27th and get the boat on the morning of the 28th. I think.
I bet that aluminum tread plate would look good anodized black. But, the powder coat is probably better at resisting corrosion, I'm guessing.
Garrett
#8
Registered
Thread Starter
Join Date: Sep 2003
Location: Toledo, Ohio/Las Vegas, NV
Posts: 3,029
Likes: 0
Received 1 Like
on
1 Post
Re: Engine room treadplate
Originally Posted by lonestar382
I'm ready to see what it looks like installed
Corey
Corey