OEM oil pressure gauge
#1
Registered
Thread Starter
Join Date: Aug 2002
Location: Eastern Lake Ontario
Posts: 2,896
Likes: 0
Received 3 Likes
on
3 Posts
OEM oil pressure gauge
Anyone have an old, OEM VDO oil pressure gauge, 1989 vintage? (square bezel style) One gauge on my 311 is bad. Replaced sender and checked all connections. Reading is still all over the place, bounces up and down and sticks high and low.
#2
Registered
ThirdBird,
I have a complete set of OEM VDO's from my 292, it is a 91'. It did not have the square bezels. It's possible that the same gauge goes int the bezel though. Can you remove the gauge from the bezel? My gauges just twisted out from the panel from behind. They may fit into your bezels.
I have a complete set of OEM VDO's from my 292, it is a 91'. It did not have the square bezels. It's possible that the same gauge goes int the bezel though. Can you remove the gauge from the bezel? My gauges just twisted out from the panel from behind. They may fit into your bezels.
#3
Registered
Thread Starter
Join Date: Aug 2002
Location: Eastern Lake Ontario
Posts: 2,896
Likes: 0
Received 3 Likes
on
3 Posts
Treads,
I think the bezels come right off. But, I can't remeber what your 1991 gauges look like. Someone else here may know if they are the same. If so, hope we can make a deal.
I think the bezels come right off. But, I can't remeber what your 1991 gauges look like. Someone else here may know if they are the same. If so, hope we can make a deal.
#5
Registered
#8
Registered
#10
Registered
Third,
The FedEx guy did not pick up the package with the sender today, so I am dropping it off at the FedEx store tomorrow. Sorry about that. You'll have it Friday so you will be good for the weekend.
Tim
The FedEx guy did not pick up the package with the sender today, so I am dropping it off at the FedEx store tomorrow. Sorry about that. You'll have it Friday so you will be good for the weekend.
Tim
Thread
Thread Starter
Forum
Replies
Last Post
Waterfoul
General Boating Discussion
7
06-15-2003 08:18 PM