Put the bird in a nest
#41
Registered
Thread Starter
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
More 3......exhaust parts.......hole where the TV cracked in half and fell out of.....redesigning this area. Factory engine rigging mess we need to deal with.
#44
Registered
Thread Starter
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
Here are two of the old ones. I didn't even bother getting them tested or anything.
#45
Registered
Just curious really.
#46
Registered
Thread Starter
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
Oh.....those! So many parts. The Whipple intake manifolds are not plated at all. No matter what, they corrode. Also, the casting does not align with the gaskets they provide which also causes a water resriction. I had to machine the new ones and we also blue hard anodized the complete part. The new ones pictured here we sent back to them and got the non-painted ones so we could anodize the whole part.
#47
Registered
Wow, with no coating at all it's no wonder they corrode! Can't believe they can't even get a gasket that matches properly
The boat is really looking good, can't wait to hear the results with the new motors.
The boat is really looking good, can't wait to hear the results with the new motors.
#48
Registered
Thread Starter
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
It's the same motors......just a rebuild all the way to the bottom........to the bottom of my bank account!
#49
Registered
Just remember you can`t take it with ya
#50
Registered
Thread Starter
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
Following my lead from 3 years ago, eh?
Handy tips for Nort
Handy tips for Nort