Steering Wheel Centers - Winter Project
#1
Registered
Thread Starter
Join Date: May 2002
Location: Cumming GA
Posts: 931
Likes: 0
Received 0 Likes
on
0 Posts
Steering Wheel Centers - Winter Project
If anyone is interested, I can engrave the steering wheel centers with the Fountain Logo. You will have to send me your center and the turn around time will be a few days. If you need other parts engraved let me know
I also still have some of the rubrail trim caps still available.
Todd
I also still have some of the rubrail trim caps still available.
Todd
#4
Registered
Thread Starter
Join Date: May 2002
Location: Cumming GA
Posts: 931
Likes: 0
Received 0 Likes
on
0 Posts
Re: Steering Wheel Centers - Winter Project
Laser engraved.
cost will be $5 plus shipping. Most locations in the US will be about $3.50 for FedEx.
Since these will be done one at a time, we may have to do a small test engraving on the back side to ensure the best quality engraving. If you have a silver part the engraving will show as a matt silver/white engraving.
If you wish to have yours done, just send the center piece and a check to:
Todd Howerton
Outlaw Disc Brakes
1465 Ventura Drive
Cumming GA 30040
770-844-1777
Thanks, Todd
cost will be $5 plus shipping. Most locations in the US will be about $3.50 for FedEx.
Since these will be done one at a time, we may have to do a small test engraving on the back side to ensure the best quality engraving. If you have a silver part the engraving will show as a matt silver/white engraving.
If you wish to have yours done, just send the center piece and a check to:
Todd Howerton
Outlaw Disc Brakes
1465 Ventura Drive
Cumming GA 30040
770-844-1777
Thanks, Todd
#6
Registered
Thread Starter
Join Date: May 2002
Location: Cumming GA
Posts: 931
Likes: 0
Received 0 Likes
on
0 Posts
Re: Steering Wheel Centers - Winter Project
Back4More,
That would be great. The version that I have is scanned and works fine for the small trim piece but is not good for the larger stuff without a lot of clean-up. Jpeg is probably the easiest to work with in the lasering software.
Thanks, Todd
toddh@outlawdiscbrakes. com
That would be great. The version that I have is scanned and works fine for the small trim piece but is not good for the larger stuff without a lot of clean-up. Jpeg is probably the easiest to work with in the lasering software.
Thanks, Todd
toddh@outlawdiscbrakes. com
#7
Platinum Member
Platinum Member
Join Date: Jun 2003
Location: Stonybrook, NY
Posts: 431
Likes: 0
Received 0 Likes
on
0 Posts
Re: Steering Wheel Centers - Winter Project
My wheel center is made of plastic and has the "Gaffrig" logo on it...too bad, I would have liked to have the Fountain logo, looks great!
GCF
GCF