500 efi intake manifold needed!
#1
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Finally my motor is going in and it is found that the intake manifold is coroded and needs replacing. Does anyone have a lower intake for the 500 efi maybe from a whipple takeoff. Thanks, Marty.
#2
Registered
![Default](/forums/images/icons/icon1.gif)
Originally Posted by cobra marty
Finally my motor is going in and it is found that the intake manifold is coroded and needs replacing. Does anyone have a lower intake for the 500 efi maybe from a whipple takeoff. Thanks, Marty.
903 786 3797 Matt
#4
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Matt I'll call you today. Phantom PM with what you have.
I want two lowers and I am going to cut the runners down on one about 1-1 1/2" and then send them to Extrude hone where they will flow them before and after their extrude hone process. I will have 4 sets of data to look at.
I want two lowers and I am going to cut the runners down on one about 1-1 1/2" and then send them to Extrude hone where they will flow them before and after their extrude hone process. I will have 4 sets of data to look at.
Thread
Thread Starter
Forum
Replies
Last Post
2 Trick Rick
General Q & A
8
11-10-2006 03:50 PM