Drive stand project.
#1
Registered
Thread Starter
Join Date: Dec 2002
Location: Kankakee Illinois
Posts: 3,705
Likes: 0
Received 0 Likes
on
0 Posts
Drive stand project.
A few weeks ago I picked up a couple of speedmaster 3As for my top gun project. Along with the drives I picked up the need for a couple of stands. After reviewing my requirements and doing a couple of rough sketches, this is the design that I came up with. I still need to put on a couple of finnishing touches on the first one before it is ready for paint but the first test fitting went very well. I thought that I would share some of the pictures that I took along the way.
Roger
Roger
#7
Registered
Thread Starter
Join Date: Dec 2002
Location: Kankakee Illinois
Posts: 3,705
Likes: 0
Received 0 Likes
on
0 Posts
Re: Drive stand project.
Originally Posted by RollWithIt
Why dont you just go with the bare metal look. I kinda like the raw finish better than paint.
I do too Jason but if I don`t paint them, I will have the rusty drive stand look before too long.
#9
Registered
Thread Starter
Join Date: Dec 2002
Location: Kankakee Illinois
Posts: 3,705
Likes: 0
Received 0 Likes
on
0 Posts
Re: Drive stand project.
Originally Posted by NASTY HABIT
looks good ....now start polishing them.
#10
Registered
Join Date: Dec 2002
Location: Bucyrus, Ohio
Posts: 6,654
Likes: 0
Received 0 Likes
on
0 Posts
Re: Drive stand project.
Wow, nice work. I was thinking about starting a thread ealier today about drive stands to get some ideas. I want something that doesnt take up much space, and can easily move around smaller drives like X's and XR's and the occasional Alpha.