Catalytic Coverters by 2008...Bummer
#1
Registered
Thread Starter
Join Date: Feb 2002
Location: Lake Michigan
Posts: 6,627
Likes: 0
Received 0 Likes
on
0 Posts
Catalytic Converters by 2008...Bummer
Was reading about the EPA and CARB pushing the 5-gm HC=NCx Standard to be in place by 2008.
This means Catalytic Converters for marine inboard and stern-drive engines...but at the next meeting considerations are being made to exempt engines over 500hp. I'm sure the CARB Board of directors will include all marine engines regaurdless the amount of power.
Better buy that big power boat before 08.
This means Catalytic Converters for marine inboard and stern-drive engines...but at the next meeting considerations are being made to exempt engines over 500hp. I'm sure the CARB Board of directors will include all marine engines regaurdless the amount of power.
Better buy that big power boat before 08.
Last edited by Back4More; 01-24-2008 at 03:54 AM.
#3
A to Z
Platinum Member
Re: Catalytic Coverters by 2008...Bummer
Originally Posted by Back4More
Was reading about the EPA and CARB pushing the 5-gm HC=NCx Standard to be in place by 2008.
This means Catalytic Coveters for marine inboard and stern-drive engines...but at the next meeting considerations are being made to exempt engines over 500hp. I'm sure the CARB Board of directors will include all marine engines regaurdless the amount of power.
Better buy that big power boat before 08.
This means Catalytic Coveters for marine inboard and stern-drive engines...but at the next meeting considerations are being made to exempt engines over 500hp. I'm sure the CARB Board of directors will include all marine engines regaurdless the amount of power.
Better buy that big power boat before 08.
#7
Gold Member
Gold Member
Re: Catalytic Coverters by 2008...Bummer
A red hot cat conv in a glass boat with carpet and ropes...a recipe for a fiery disaster
Doesn't the Coast Guard Regs say that the exhaust system can't go over 200* in temp? A catalytic converter can't be water cooled because it needs the high heat to light off.
#8
Registered
VIP Member
Re: Catalytic Coverters by 2008...Bummer
They may try to get the emissions down, but it won't be a catalytic converter as we know it now. Like Iggy said: It needs the heat for the chemical to "convert" the emissions. Totally not practical in a closed bilge.
#9
Registered
Join Date: May 2002
Location: Deeee-troit!
Posts: 3,358
Likes: 0
Received 0 Likes
on
0 Posts
Re: Catalytic Coverters by 2008...Bummer
Originally Posted by Edward R. Cozzi
They may try to get the emissions down, but it won't be a catalytic converter as we know it now. Like Iggy said: It needs the heat for the chemical to "convert" the emissions. Totally not practical in a closed bilge.
Yet another reason I am SO glad we didn't relocate out to the land of fruits and nuts; 6 months in that place and I'd be shooting someone....
#10
Registered
Re: Catalytic Coverters by 2008...Bummer
A typical oxidizing catalytic convertor needs to reach 600 degrees F to start functioning. Its basically a chemical furnace. The fact that most marine engines run at 12 to 1 a/f ratio will also be a huge problem to overcome with a cat. Cats like 14.7 to 15.2 to 1 to function properly. At 12 to 1, the life expectancy of the cat would be somewhere between short and none.