Rod Bearing "Take A Look"
#1
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Here is a pic of 1 of the rod bearings out of a motor of mine.
They all looked good Mains & rods , The crank looked great.
However all 8 of the upper half rod bearings looked like this 1 in the picture. Bottom rod bearings looked perfect. Any engine guys want to give their insite please feel free.
They all looked good Mains & rods , The crank looked great.
However all 8 of the upper half rod bearings looked like this 1 in the picture. Bottom rod bearings looked perfect. Any engine guys want to give their insite please feel free.
#5
Registered
Thread Starter
#6
Platinum Member
![](https://www.offshoreonly.com/forums/images/icons/platinum_member_star.gif)
![Default](/forums/images/icons/icon1.gif)
Some kind of detonation at one point,I just tore down my 540 blower motor (114 hours/950 hp) clevite h-series bearings,looked like they just came out of the pkg,other than a few rings that had spun around on the pistons and lined up there was zero signs of detonation,Smitty
#9
Charter Member
![](https://www.offshoreonly.com/forums/images/icons/charter_member_star.gif)
![Default](/forums/images/icons/icon1.gif)
Long term, low level detonation.