Exhaust turn-downs: How deep under water?
#22
Registered
GGB inserts
I'm running 1400 hp Teague motors at 110 decibels. I must get the noise down to 90. I just purchased turn downs from Gibson. Any suggestions or concerns I should be aware of?
- Reversion? - Motors stalling at idle? - How deep should they be? - Back pressure relief holes?
Any suggestions would be helpful. Thanks
- Reversion? - Motors stalling at idle? - How deep should they be? - Back pressure relief holes?
Any suggestions would be helpful. Thanks
The following users liked this post:
JanTore (07-14-2023)