Need help with engine instalation.
#1
Registered
Thread Starter
Join Date: Oct 2001
Location: Toledo Oh
Posts: 1,915
Likes: 0
Received 0 Likes
on
0 Posts
Need help with engine instalation.
I'm getting ready to put my engines back in and I forgot how the transom came appart. Dose the little lock washer looking thing go between the bellhousing and the transom plate on a bravo aplication? Let me know. Thanks
#2
Team Dysfunctional
Charter Member
Join Date: Jan 2001
Location: Bolton Landing NY
Posts: 1,420
Likes: 0
Received 0 Likes
on
0 Posts
There is some kind of fiber washer that goed there. any manual should have a diagram. I will look to see if I have mine here. if I do I will copy it and email you the diagram
#4
Team Dysfunctional
Charter Member
Join Date: Jan 2001
Location: Bolton Landing NY
Posts: 1,420
Likes: 0
Received 0 Likes
on
0 Posts
.The photos in the manual aren't worth copying. They show the bolt first, then a steel washer , and a spacer. then in between the bell housing and the transom assembly they have a spiral split lock washer and a fiber washer under that. Hope this helps
#5
The double wound spring washer goes inside the larger fiber washer--- tape (masking) these to the transom plate in the proper alignment with the hole. Set the engine in place then the bolt with the large steel washer and the steel spacer about 3/4 inch long goes down the hole. also tape the nut from sliding out of place on the bottom of the transom plate engine mount part. These bolts need to be tight. Next step is to always check the drive alignment. This is a must....
Thread
Thread Starter
Forum
Replies
Last Post
Clay Washington
General Boating Discussion
101
01-16-2006 02:27 PM
JGB
General Q & A
40
02-16-2005 10:26 AM
timucin
General Q & A
11
09-23-2002 10:26 AM