496 MAG - one uses more fuel and lower max RPM???
#1
Registered
Thread Starter
Join Date: Jun 2010
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
496 MAG - one uses more fuel and lower max RPM???
Twin 496 MAGs with Smartcraft. At low RPM both engines show the same GPH at same RPM.
Above approx. 3000 rpm, the port motor needs more throttle to stay at the same RPM and begins to use more GPH. At 3500 rpm, port uses approximately 4 more GPH. At full throttle there is a 300-400 RPM difference (4400 port vs 4800 starboard).
Both throttles are adjusted the same. What could the problem be? Any ideas appreciated.
Above approx. 3000 rpm, the port motor needs more throttle to stay at the same RPM and begins to use more GPH. At 3500 rpm, port uses approximately 4 more GPH. At full throttle there is a 300-400 RPM difference (4400 port vs 4800 starboard).
Both throttles are adjusted the same. What could the problem be? Any ideas appreciated.
#2
Registered
Look for a plug wire that has fallen off a spark plug on the port motor. 496's are notorious for having plug wires fall off.
#3
Registered
Thread Starter
Join Date: Jun 2010
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
#6
Registered
Thread Starter
Join Date: Jun 2010
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Any 496 experts that might be able to help? I have two weeks of warranty left and something is not right.
I just paid for 3 hours of a Merc service guy looking at the computer and the plug wires ... nothing.
But the problem remains: 3500 rpm about 3 gph more on the port; 4000 rpm about 5 gph more on the port; full throttle is 4300-4400 on port and 4700-4800 on starboard. At full throttle gph is the same.
It seems like i am down a cylinder, but the computer has no fault codes or other problems (I have not had the computer on when the engines were loaded).
I don't want to keep paying my service guy to go on a witch hunt. Any help appreciated.
I just paid for 3 hours of a Merc service guy looking at the computer and the plug wires ... nothing.
But the problem remains: 3500 rpm about 3 gph more on the port; 4000 rpm about 5 gph more on the port; full throttle is 4300-4400 on port and 4700-4800 on starboard. At full throttle gph is the same.
It seems like i am down a cylinder, but the computer has no fault codes or other problems (I have not had the computer on when the engines were loaded).
I don't want to keep paying my service guy to go on a witch hunt. Any help appreciated.
Last edited by oz boater; 06-05-2010 at 08:50 PM.
#9
Charter Member #1055/Moderator
Charter Member
If compression is the same, I doubt a leakdown will show you anything. As Julie brought up, you might try a differend set of props or swapping them and see if the problem follows the prop.
__________________
[img][/img]
[img][/img]