Oil Filter stuck Tried Everything!
#11
Charter Member#330
Charter Member
Silly question, but you guyshaving trouble with removing your filters are you putting oil on the gasket before putting the filter on?
Sorry no addtional advice on removal other then what has already been mentioned
Sorry no addtional advice on removal other then what has already been mentioned
__________________
If you like it rough do it OFFSHORE!!!
If you like it rough do it OFFSHORE!!!
#13
Registered
I struggle with mine too. This year I got to use the gigantic channel-locks on em (what fun !!!). I had to squeeze the bejesus outta the canisters. So are we putting them on too tight ? I also use a clean, dry towel...then just hand power to install. I think it says on the box to go 1/4 turn past initial gasket contact. I was always leary of that, so I turned em a bit more (probably too much). Are we all tightening them too far ?
#14
Registered
Join Date: Jan 2009
Location: Wilson, NY
Posts: 935
Likes: 0
Received 0 Likes
on
0 Posts
I'll start only turning them 1/4 turn sir... but you better come runnin from Jersey with a hand full of SHAM-WOW'S if they leak !!!!! lol
#15
Registered
Thread Starter
Join Date: Mar 2007
Location: Lake Dallas, TX
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
#16
Registered
Thread Starter
Join Date: Mar 2007
Location: Lake Dallas, TX
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
Mine was the same way last winter. I ended up making a "tool" because the canister was torn apart. Took a piece of wood and using the new one as a template, put two bolts through the wood that would go into the openings on the screw-on part. Got what was left of it off easily. My bilge is still a mess though.
#17
Registered
Thread Starter
Join Date: Mar 2007
Location: Lake Dallas, TX
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
While in the bilge I took a sawzall to it, got rid of 90% of the can, sawed into the base of the can on the edge so my screw driver could get the most amount of torque, and I tried my best whacking the screw driver with the hammer, didn't budge, but my knuckle on my hand is nice and bruised.!!!!
I'm just going to remove the hoses and the adapter, put in a vice. This way I have a much better swing and if I miss and destroy my adapter, I DON'T CARE because I'm so pissed right now!!!!!!!
EOM
I'm just going to remove the hoses and the adapter, put in a vice. This way I have a much better swing and if I miss and destroy my adapter, I DON'T CARE because I'm so pissed right now!!!!!!!
EOM
#20
Registered
Join Date: Jan 2009
Location: Wilson, NY
Posts: 935
Likes: 0
Received 0 Likes
on
0 Posts
If your gonna do that...then try getting the filter top (part with the o-ring) into the vise. Squeeze the nuts outta it...and turn your adapter. This way your not whacking anything.