IMCO's New Dual Down Shaft Lower
#12
Registered
#13
Charter Member # 55
Charter Member
Copied from FB post
Jeff Harris is at Harris Performance LLC.
August 28 at 11:17 PM · Dadeville, ALI've been sworn to secrecy, but the word is out now and I'm proud to say that we have came far enough in this business to where we were able to be the first ones in the nation to not only see, but trial the new Imco Marine dual downshaft sc lower. Imco trusted us enough to send us the only set in existence to run on our procharged Cigarette. We had multiple issues shredding lowers with the heavy boat that was cranking out 975 pounds and 1100 horsepower with the procharged engines we did for it. Long story short, the boat would shred a lower at every event it attended, and after the dual downshaft lower, the boat has went an entire season including havasu and loto without a single hiccup. Imco knocked it out the park here, if the bigger gearcase scx lower isn't for you, if the sc lower is to wimpy for you, if the swap to a number 6 isn't for you, you be gotta check out this lower, it's a real game changer!!
#14
VIP Member
VIP Member
So these are smaller then the standard SCX lower?
#16
Offshoreonly Advertiser
Offshoreonly Advertiser
Thread Starter
__________________
www.diamondperformanceparts.com
[email protected]
http://www.facebook.com/pages/Diamon...07878772615803
302-521-0123
The Best Parts & Service At The Best Price
www.diamondperformanceparts.com
[email protected]
http://www.facebook.com/pages/Diamon...07878772615803
302-521-0123
The Best Parts & Service At The Best Price
#17
VIP Member
VIP Member
Wonder if we’ll see an uptick in used SCX’s in the classifieds?
#18
Banned
It was out at the havasu street party back in April. The one pic I took and talk to IMCO in person plus the testing started back before then and continued in April It was not any secret and if you at the street party Havasu back then it was on displayed at HERBS the whole time for anyone to see and throw out your questions.
Last edited by BUP; 08-30-2018 at 09:16 AM.
#19
Registered
Are they faster than the standard SC lower or just stronger?
#20
Registered
Will it bolt to a SCX-4? Would it put the prop 2" deeper?
Does it come "blueprinted"?
Is the propshaft stronger yet? I've seen several break and lose the prop too.
Who makes a prop for a 1.25" shaft that won't sling blades while surfacing?
Does it come "blueprinted"?
Is the propshaft stronger yet? I've seen several break and lose the prop too.
Who makes a prop for a 1.25" shaft that won't sling blades while surfacing?