Hatch is done.....
#3
Charter Member #737
Charter Member
Looks good. I need to get around and finish mine had the scoop for two years now.
#4
VIP Member
VIP Member
Looks good,
One word of advice:
If you raft up alot, keep an
eye on who's crossing over,
mine lasted less than 1
day before one of my slightly
intoxicated buddies thought
he could step on the scoop,
CRACK,POP, REPAINT
One word of advice:
If you raft up alot, keep an
eye on who's crossing over,
mine lasted less than 1
day before one of my slightly
intoxicated buddies thought
he could step on the scoop,
CRACK,POP, REPAINT
#5
Registered
Where do you get them, and what size is it? How much more can you hear the motor? How did you attatch, bolt through? I've looked at Summit and Jeg's but don't know what size to get.
#6
Registered
Thread Starter
Join Date: Nov 2001
Location: Palm Harbor, FL
Posts: 3,959
Likes: 0
Received 0 Likes
on
0 Posts
jt29 - I'll keep that in mind. This thing is solid as a rock tho. The wife hates it !!! I was not and still am not the most favorite of her right now. She say's that I did not tell her I was going to put a quote:"Blower Thing" on the hatch. She also said that "Hot Air" will come out of it. I know she's mad but I can't help but laugh at her......Wardey
#7
Registered
Thread Starter
Join Date: Nov 2001
Location: Palm Harbor, FL
Posts: 3,959
Likes: 0
Received 0 Likes
on
0 Posts
Pure Energy - I had the hatch built with the scoop. It's all fiberglass. I'll post more pic's of the underside later. As far as engine noise, I couldn't tell you right now, I havn't started her up yet......Wardey
#8
VIP Member
VIP Member
Wardey,
My wife and her friends hate mine too !!
their "dance floor" is in the upolstery shop
getting reskinned, but I'm in no hurry
to put it back on
Pure Energy,
I used Harwood 3163 p/n
bonded them on, if I had to
do it again, I would use the
4163, that is the bolt on.
As far as noise, I really didn't
notice any increase.
I have pictures posted in the
Baja section, thread name: picture test,
that show what mine look like.
My wife and her friends hate mine too !!
their "dance floor" is in the upolstery shop
getting reskinned, but I'm in no hurry
to put it back on
Pure Energy,
I used Harwood 3163 p/n
bonded them on, if I had to
do it again, I would use the
4163, that is the bolt on.
As far as noise, I really didn't
notice any increase.
I have pictures posted in the
Baja section, thread name: picture test,
that show what mine look like.
Last edited by jt29olhp500s; 03-04-2003 at 03:20 PM.