IMCO on 22' Velcity?
#1
Guest
Posts: n/a
IMCO on 22' Velcity?
Wondering about an imco shorty drive on my boat.
I talked to Velocity about it and they gave me the run around, evetually the guy told me they haven't tested it before. Has anybody heard of any results of this combo?
Also Smoke on water the water would have been alot better without the smoke on the water.
I talked to Velocity about it and they gave me the run around, evetually the guy told me they haven't tested it before. Has anybody heard of any results of this combo?
Also Smoke on water the water would have been alot better without the smoke on the water.
#4
Registered
Join Date: Feb 2003
Location: LaPorte, Indiana
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
I switched from a 3 blade spinelli to a 4 blade lab finished bravo from Velocity. It made quite a bit of difference in the handling of the boat. The boat is still not a sit down and put the throttle down type of boat. You have to really drive the boat. It took me over a year to finally get the trim and a few other things figured out to get the boat to run. Once you find that trim point, this boat just sits back and goes.
#5
Guest
Posts: n/a
I'm doing 92mph on handheld GPS with 4 blade 30 pitch bravo non lab finish. I'm hoping to get my hands on a 30 lab finish to try and get me up to 5200-300 hundred RPM's. Right now I'm spinning at 5100 rpm's. I was running a Hyrdo Motive 4 blade 28 non labbed before and was hitting the rev limiter. I want to get into the upper 90's. When you say two inches below the hull are you talking the X dim?