Mesa delivers Otis Tiger
#1
Registered
Thread Starter
Mesa delivers Otis Tiger
Alright back in Feb we saw Otis off to the poker run the day following splash date and I must say I was nervous I wanted Bob to have a great time with his family and friends knowing what he'd been through . We had a couple of small issues nothing major . Monday I spoke to Bob about leaving his baby and letting me test some props and change some things in the mufflers when he told me he would be back in April to take her back home . The result has been I feel good to say we picked up from 71 mph to 77-78 in flat water unfortunately yesterday when we went out for the last test we went out and there was 6 to 8 footers instead of the advertised 2 to 4 we expected and I couldn't get him his 80mph we were looking for but I know it will go there in the right condition .
#4
Registered
Thread Starter
Re: Mesa delivers Otis Tiger
Otis went with the MB700na's they are a 572ci with Brodix cnc heads Dart's single plane intake and a 1050cfm these engines are simple proven combos Bob will enjoy . The flame arrestors are stainless polished . Sincerely yours Laz
#5
Registered
Join Date: Oct 2000
Location: Fells Point MD
Posts: 532
Likes: 0
Received 0 Likes
on
0 Posts
Re: Mesa delivers Otis Tiger
Laz, I see no bypass at the crossover. Are you using restrictor plates in the thermostat housing, or just letting the water blast through?
thanks
Shawn
thanks
Shawn
#6
Registered
Thread Starter
Re: Mesa delivers Otis Tiger
Originally Posted by shawn
Laz, I see no bypass at the crossover. Are you using restrictor plates in the thermostat housing, or just letting the water blast through?
thanks
Shawn
thanks
Shawn
#7
Registered
Thread Starter
Re: Mesa delivers Otis Tiger
Originally Posted by shawn
Laz, I see no bypass at the crossover. Are you using restrictor plates in the thermostat housing, or just letting the water blast through?
thanks
Shawn
thanks
Shawn