Advise, Is This Cam To Big?
06-11-2005, 03:03 PM
#11
Registered
Thread Starter
Re: Advise, Is This Cam To Big?
Don't forget the hoses also 
I just went to a company in town that makes them. Only cost $30 for all three.
I just went to a company in town that makes them. Only cost $30 for all three.
06-11-2005, 05:20 PM
#12
SORE MEMBER
Platinum Member
Join Date: Apr 2004
Location: 29°50'49.74"N 95° 5'17.55"W.......TEXAS
Posts: 6,989
Likes: 0
Received 1 Like
on
1 Post
Re: Advise, Is This Cam To Big?
Originally Posted by 1BIGJIM
How do you clean an oil cleaner after a spun bearing? That's what I thought I did and wiped out another engine. I cut the old one open this week, I don't see how you could take one apart and clean it. Bought a new one for $200 at the dealer.
JIM
Any more comments on that cam?
JIM
Any more comments on that cam?
06-11-2005, 10:28 PM
#13
Registered
Re: Advise, Is This Cam To Big?
Originally Posted by 1BIGJIM
I just wiped out an engine with 10 hours because I was not smart enough to change the oil cooler from a previous spun bearing 
Sand Paper
Roby
06-12-2005, 06:47 PM
#14
Registered
Join Date: Nov 2001
Location: Pompano Beach, Florida
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
Re: Advise, Is This Cam To Big?
Over 225 duration results in reversion. Use only long stainless risers to inject the water into the exhaust stream at a further point aft. No problem with the cam if you have long risers.
