Replacing Guages
#2
Were doomed!
Charter Member
Re: Replacing Guages
If you have a panel on your boat you will need to unscrew it and lift it up to get to the back of the gauges....there you will see a "U" bracket held down by two nuts undo those and the guage will be loose.....then just make sure to either mark/take pictures or remember where each wire goes back.
If no panel then you have to figure out how they installed the gauges....maybe from under the dash? Or maybe from behind in the cabin?
If no panel then you have to figure out how they installed the gauges....maybe from under the dash? Or maybe from behind in the cabin?
__________________
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
#4
Were doomed!
Charter Member
Re: Replacing Guages
it depends on what kind of bezel you have....if its one thats under the gauge then t just sits there sandwhiched between the gauges and the dash......if you have the colored trim ring on the gauges itself then you are SOL cause you cant take those off.....you'll know realy quick once the gauge is loose...
__________________
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!