525SC lifters and valve springs

Reply Subscribe

Thread Tools

08-11-2005, 07:33 PM

dykstra

Platinum Member

Thread Starter

Join Date: Dec 2003

Location: Washington, IL

Posts: 6,021

Likes: 4,826

Received 259 Likes on 144 Posts

525SC lifters and valve springs

Any suggestions for lifters and valve springs. I am ordering the stock cam. Crane#132561.

08-12-2005, 10:29 AM

dykstra

Platinum Member

Thread Starter

Join Date: Dec 2003

Location: Washington, IL

Posts: 6,021

Likes: 4,826

Received 259 Likes on 144 Posts

Re: 525SC lifters and valve springs

ttt

08-12-2005, 11:57 AM

PatriYacht

Registered

Join Date: Jul 2002

Location: Waterford,MI

Posts: 2,867

Likes: 0

Received 2 Likes on 2 Posts

Re: 525SC lifters and valve springs

Just order the stuff that Crane reccomends. I had the same cam in my Cyclone 400s for 11 years and 600+ hours with no problems whatsoever. Be careful at cam breakin time. DO NOT IDLE FOR THE FIRST 20 MINUTES.

08-12-2005, 03:25 PM

MESABALANCING

Registered

Join Date: Mar 2004

Location: Miami, FL

Posts: 726

Likes: 0

Received 9 Likes on 6 Posts

Re: 525SC lifters and valve springs

I agree to ensure your self the breakin is going right crack the valve covers loose and make sure your pushrods are all turning do this by marking the pushrod with white marker if all the pushrods are turning it will last for ever if you have any that don't turn stop because it will scrub the lobe and you'll have to start all over again. Good luck to you.