Mesa MB650na weekly project
#1
Registered
Thread Starter
Mesa MB650na weekly project
Here is a couple of pics of a friends engine were finishing up he opted for the aluminum heads instead of Iron and all the goodies in the valve trane and the bottom like always only the best American made stuff no imported parts it's going in a 26 footer going to be lots of fun . I'll post the dyno numbers as soon as I have them available and if anyone knows how to post video I can post the dyno video. Here is the block with the rings all filed fit individually to each cyl. the pistons after massaged weighed and debured also the heads checking spring press and installed height.
#2
Registered
Thread Starter
Re: Mesa MB650na weekly project
here are some pics after cc'ing the heads and the Jesel components cleaned ready for assembly and the short block assembled with the cam degreed and ready for pan to go on. Hope you guys like.
#5
Registered
Thread Starter
Re: Mesa MB650na weekly project
Chris these lifters are Cam Motion and they are made by John Callies that use to make the Callies cranks . I've never used the Morels I'd like to do so testing with them since you told me you were reping them I've just been so busy I haven't had time to bother you about them.
#6
Registered
Thread Starter
Re: Mesa MB650na weekly project
Originally Posted by Viper31
Laz,
Is this a new package you will be offering in between your 600 and 700?
Is this a new package you will be offering in between your 600 and 700?
#8
Re: Mesa MB650na weekly project
Originally Posted by MESABALANCING
Can someone tell me how to post a video of the dyno work
www.putfile.com
or
www.gig.com
No porn on putfile
__________________
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
Thread
Thread Starter
Forum
Replies
Last Post
MESABALANCING
General Q & A
8
07-11-2005 09:59 AM