TRS gimbal question
#2
Registered
Join Date: Feb 2002
Location: Honeoye, NY
Posts: 763
Likes: 0
Received 0 Likes
on
0 Posts
Re: TRS gimbal question
Not that I am aware of, other than the thru-transom steering arm and it's mating pivot pin went from the original splined connection to square in later production. --- Jer
#4
Registered
Join Date: Jan 2001
Location: ST. Louis, MO, USA
Posts: 1,658
Likes: 0
Received 0 Likes
on
0 Posts
Re: TRS gimbal question
Both the arm and gimbal ring went from spline to square, but not at the same time. So you can have a spline/spline, spline/square, or square/square upper swivel pins with corresponding arm and ring.
#5
Charter Member #232
Charter Member
Re: TRS gimbal question
Originally Posted by Gary Anderson
Both the arm and gimbal ring went from spline to square, but not at the same time. So you can have a spline/spline, spline/square, or square/square upper swivel pins with corresponding arm and ring.
Jon
__________________
Put your best foot forward!
Put your best foot forward!
#6
Registered
Join Date: Jan 2001
Location: ST. Louis, MO, USA
Posts: 1,658
Likes: 0
Received 0 Likes
on
0 Posts
Re: TRS gimbal question
Hmmm, never heard that before. I though they switched to square because the splines had a bad habit of freezing in place.
Originally Posted by Audiofn
You got it and the Square/Square is the best out of them all. The Spline units were much weaker. I just swapped out a spline spline unit on my Donzi because I did not want to have to worry about it.
Jon
Jon
#7
Registered
Thread Starter
Re: TRS gimbal question
I believe I have one with splines, and one with square/square steering. I will not be putting a lot of HP through them. I was just making sure the dimensions are the same before i plan to install them. can you change the bellhousing to the square/square configuration or do you need everything to switch over. I picked up the transom assembly for $100 with low hours.
Last edited by Prater; 09-27-2005 at 01:44 PM.
#8
Charter Member #232
Charter Member
Re: TRS gimbal question
Originally Posted by Gary Anderson
Hmmm, never heard that before. I though they switched to square because the splines had a bad habit of freezing in place.
__________________
Put your best foot forward!
Put your best foot forward!
#9
Charter Member #232
Charter Member
Re: TRS gimbal question
Originally Posted by Prater
I believe I have one with splines, and one with square/square steering. I will not be putting a lot of HP through them. I was just making sure the dimensions are the same before i plan to install them. can you change the bellhousing to the square/square configuration or do you need everything to switch over. I picked up the transom assembly for $100 with low hours.
Jon
__________________
Put your best foot forward!
Put your best foot forward!