HP500EFI fuel pressure attachment point
#1
Registered
Thread Starter
Join Date: Apr 2005
Location: Castro Valley, California
Posts: 62
Likes: 0
Received 1 Like
on
1 Post
HP500EFI fuel pressure attachment point
Can anyone tell me where is the easiest and correct point to take a fuel pressure reading on that engine. I am looking for the place to plumb in a "tee", for the line to the guage, thanks.
#2
Registered
Re: HP500EFI fuel pressure attachment point
There's probably better places but I've had a small high pressure hoses made and installed where the schrader valve is on the fuel rail. I connected a sender to the end of the hose for an electrical gage but this would also work for a mechanical type also.
Dave
Dave
#3
Re: HP500EFI fuel pressure attachment point
I took the shrader valve out of it and just put a # 4 hose on where I conected my gage for testing , then just put a cap on it.
__________________
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
#4
Registered
Thread Starter
Join Date: Apr 2005
Location: Castro Valley, California
Posts: 62
Likes: 0
Received 1 Like
on
1 Post
Re: HP500EFI fuel pressure attachment point
THANKS GUYS Just went on a site showing the fuel rail breakdown. The schrader vale looks a good place to tap into. There is also a pipe plug on the far end of the rail on the bottom where the regulator mounts that may be an option. What ever is easier to access is where I'll tap into.
Thread
Thread Starter
Forum
Replies
Last Post
JGB
General Q & A
32
10-24-2004 09:28 PM
FlyFast
General Q & A
6
07-18-2002 06:12 AM