Bent Skeg
#1
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
The back end of the skeg on my starboard Bravo I outdrive is slightly bent from right to left. It is like a gentle roll, not a hard bend. Can I add some heat and bend it back? Has anyone had any experience doing this? If yes, what is the best approach without possibly cracking the skeg? Thanks,
DL
DL
#3
Charter Member #601
![](https://www.offshoreonly.com/forums/images/icons/charter_member_star.gif)
![Default](/forums/images/icons/icon1.gif)
Like Joe said.. a big sludge hammer on one side, a buddy holding a piece of 2x4 on the other side (gloves recommended) and you with careful aim hitting the 2x4 with a 5 lb hammer... it will slowly come back into place. No garrantee it wont break, but I have done it before. If it isnt too far out of wack.. Good luck
Dick
Dick
#6
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
I tried the hammer approach today and it came back a little but it still isn't straight. I did not hit it very hard. I also tried using two 2x4's one on either side compressing them together with c-clamps. I am going to leave it compressed with the wood and c-clamps for a couple of days. It looks straight with the clamps on but returns to the bent shape when I remove the set up. I thought if I left it longer it might work. If not, I will continue tapping with the hammer and block of wood. Thanks,
DL
DL
#8
Registered
Join Date: Feb 2004
Location: Western Ma.
Posts: 578
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Originally Posted by GOODT
use two hammers or body shop dolley you need to have something solid on the back side wood is a little to soft