Help - Imco Upper to Bravo HP Bell Question
#1
Registered
Thread Starter
Help - Imco Upper to Bravo HP Bell Question
I just went to bolt my Imco SC drive to my Bravo HP bell housing and the Imco Water plumbing for the Drive shower hits the bottom tab of the bell housing. Looking at the Imco catalog, it looks like Imco's version has the bottom inch cut off their bell housing to make it fit. Can I cut the lower inch off my Bravo HP bell housing without hurting anything?
#3
Registered
Join Date: Apr 2005
Location: KENT ISLAND, MARYLAND
Posts: 2,675
Likes: 0
Received 0 Likes
on
0 Posts
Re: Help - Imco Upper to Bravo HP Bell Question
Originally Posted by JIMG
you are right. you have to cut the bottom of the bell housing to install the imco upper.
yes this is correct, been there done that
#4
Registered
Thread Starter
Re: Help - Imco Upper to Bravo HP Bell Question
Thanks for the replies - I verified with IMCO today who also confirmed what you're saying. I trimed the bottom 2 inches off today and the drive fit like a glove - thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Sydwayz
General Boating Discussion
3
04-17-2006 05:34 PM
DaveP
General Boating Discussion
0
06-22-2002 09:33 AM