no water out exhaust
#1
Registered
Thread Starter
Join Date: Mar 2004
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
built a new engine runs good sounds good engine is full of water all hoses are full, waterpump is ok i have no water coming out my exhaust could themostat be stuck
#2
Registered
![Default](/forums/images/icons/icon1.gif)
Would not be the cause.
Did you get the hoses on correct?
Typing with one hand, other in a cast
Did you get the hoses on correct?
Typing with one hand, other in a cast
![Mad](/forums/images/smilies/mad.gif)
#5
Registered
![Default](/forums/images/icons/icon1.gif)
Do you have a stock thermostat housing? If so water should be going through the by pass to the risers. Are you trying to run on a flushette? Is the drive late with both side and low water pickups? Two many un answered ?????
Phil
Phil
#7
Registered
Thread Starter
Join Date: Mar 2004
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
yes the low water pick-up is taped closed it seems to blow some water if i rev it but that is it I am going to try it in the morning by putting the lower unit in a barrel with water to see if it picks up suction
#9
Registered
Thread Starter
Join Date: Mar 2004
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
no i didn't mess with the themostat but if the housing was kind of worn on the back side of the themostat housing could that be why it might not be picking up suction there were some grooves in it but the impeller looked fine