Oil temp guage not working?
#1
Registered
Thread Starter
Join Date: Feb 2004
Location: LOTO
Posts: 1,173
Likes: 0
Received 0 Likes
on
0 Posts
Oil temp guage not working?
My port engine oil guage is not working most of the time. The sending units on both engines were replaced. The guage didn't work today until I did a WOT run and then the guage read about the same as the starboard side. Shortly thereafter, it dropped back to not reading again. Any ideas?
#3
Masher touches my
Gold Member
Join Date: Aug 2004
Location: Phoenix, Az
Posts: 2,280
Likes: 0
Received 0 Likes
on
0 Posts
Re: Oil temp guage not working?
You could also turn your ignition on and ground the wire at your sending unit. If the gauge moves all the way over then the gauge is fine and your sending unit is bad. If the gauge doesn't move then you either have a short somewhere in between, a wiring problem at the gauge, or a bad gauge. If you suspect the gauge then test for positive and ground. If you have both of those then ground the signal wire at the gauge. Once again if it moves, then your wire is bad in between, if it still doesn't move replace the gauge. It would probably be easier to run a new wire than to trace down a short.
#4
SORE MEMBER
Platinum Member
Join Date: Apr 2004
Location: 29°50'49.74"N 95° 5'17.55"W.......TEXAS
Posts: 6,989
Likes: 0
Received 1 Like
on
1 Post
Re: Oil temp guage not working?
most oil temp senders are single wire, so check for contiuity from sender body to engine, might not be making ground, test guage as BAD K suggested.
#5
Gold Member
Gold Member
Join Date: Mar 2003
Location: Grosse ile michigan
Posts: 2,373
Likes: 0
Received 87 Likes
on
35 Posts
Re: Oil temp guage not working?
throw those electrical gauges in the garbage and go with mech, at least due the important one oil press engine temp etc. i have had all kinds of problems with electric gauges.....to much money in the back of the boat to risk it..........