Adjusting lifters 1/2 3/4 maybe more?
08-24-2006, 11:34 AM
#11
Registered
Re: Adjusting lifters 1/2 3/4 maybe more?
Originally Posted by Wobble
It can get messy, but if you are able to run motor without valve cover on, you can take a balled up rag and cover each lifter in turn to see if it's just one or all of them taking turns.
Adjust the rocker arms the normal + correct way (two different methods - either is fine) and then move on to diagnosing other parts if you think this noise is still a problem.
Unfortunately noise issue diagnosing over a computer is near impossible - hard enough when looking at it live. So I can only give input which in no means may relate to your situation. Sorry.
08-24-2006, 01:56 PM
#12
Registered
Thread Starter
Re: Adjusting lifters 1/2 3/4 maybe more?
Called crane tech line. Thye said they like one full turn and no more than 1.5 on a BBC. I will give that a shot.
