Hull blueprinting in Southern California
#1
Hull blueprinting in Southern California
Who is good at Hull-blueprinting in the Southern Ca. area? I have a straight bottom 38 fever. I'm going to drop the boat off @ Paul Pfaff's in Huntington Beach to get some motor work done. Any good shops close to them? Thanks Poolshrk.
#5
Re: Hull blueprinting in Southern California
There is a palce in Tujunga called Joe's Tooling. He's about an hour from Pfaff. They do great work at real reasonable prices. I'm not sure if he will do it unless you strip it down to a bare hull so he can flip it over though.
#6
Registered
Join Date: Mar 2005
Location: Las Vegas NV
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
Re: Hull blueprinting in Southern California
If you look up a shop buy the name of MPD (marine Performance Design) Jack McClure is the owner located in Costa Mesa (SP?) CA 1760 Monrovia St. Unit A-7 949-631-2040 . He works with a guy by the name of Jeff Bennett. The only what I know how to get hold of Jeff is though Jack. Now this shop works with Jet boats. Ok Ok dont get scared just yet. these are the big guns and Jeff know his stuff. He is responsible for a lot of bottom designs.
Thread
Thread Starter
Forum
Replies
Last Post
lucky strike
General Boating Discussion
38
12-23-2004 08:18 PM
PhantomChaos
General Boating Discussion
53
01-08-2003 06:58 PM